Team Chevelle banner
1 - 5 of 5 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I have a 66 ss chevelle with a 396 that i am restoring back to original. the last owner had put in a 350 because their 396 had a crack in the block. I have no idea where something mount up such as the voltge regulator and coil resistor. SO if someone could post a picture of there engine compartment that i could see these that would be very helpful. Thanks

Grant
 

·
Registered
Joined
·
4,542 Posts
I'd guess that the voltage reg is still in the same spot it should be since there is no reason to move it. Are coil resisters factory on 66's? I didn't think they were, just a resistance wire.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top