Team Chevelle banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Here is a question for you guys, so I am rooting aroun my local junk yard and I find an old very rough 1965 2 door chevelle w/ buckets. I myself have a 1965 Chevelle w/ a bench and would like buckets. I begin inspecting these buckets for a possible swap and they are high backs, that is to say they are higher than the buckets in other 65's I have seen. Was this ever some sort of option or are these just seats out of something else (a 70's chevelle) put into this 65??
 

·
Registered
Joined
·
646 Posts
I have acess to a pair of bucket seats out of a 62 impala they look like the same style as the 64-65 chevelle except for the covers obviously, does anyone know if these will interchange with a chevelle?

Brandon

[This message has been edited by BK72SS (edited 02-18-2003).]
 

·
Registered
Joined
·
159 Posts
Brandon.. I think the seats are the same dimensions and shouls interchange but the stainless trim on the Impala seats run up the sides go across the top of the buckets and down the other side. The Chevelle seat stainless trim just goes up the two sides about 3/4 of the way to the top(like the picture shows)
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top