Search Results for ‘shifter’

I have a Hurst shifter that I pulled off of a Muncie M20. I’m looking to sell it but really not sure what price I should be asking. I’d love to hear what you guys think for a ballpark number. I appreciate any opinions.

Looking for the Hurst Reverse Loc/Out kit with a red round ball handle. Can be new or used as long as it’s at least driver quality and not missing any parts. Thanks

I have a 1972 SS Clone and put a 700R4 in with an aftermarket floor shifter. The shift cable at the transmission pulled out at the crimp at the end of the cable, then the shroud splays and goes over the crimped end, not allowing the center cable to shift the transmission. This is the second...

Available March 1, 2016 Hurst Driveline Conversions is proud to announce the release of four all NEW shifters for Tremec T-56 converted vehicles. Part #3918309 Hurst Blackjack T-56 Magnum Mid-Shifter Part #3917336 Hurst Blackjack T-56 Magnum shifter for 1959-64 Chevrolet Impalas Part...

I have a 66 chevelle malibu, with a 327/350HP engine and muncie 4 spd that came with the chevelle. I believe the shifter is stock for the corvette. the shaft of the shifter itself is very short, and hits the drivers seat when going into second gear. I don'b believe that the shifter is hurst...

Is there anyway to completely eliminate minor intermittent shifter rattle? I had a major rattle but recently had it "fixed". The situation is much improved but in some gears at some speeds there is an audible rattle. Before I go back and have them take another look at I just wanted to...

can i use the original parking lever assembly from a column shift car that activates the nss and ignition lock with a floor shifter. It seems like you should my new bracket has the holes for the lever, as the floor and column lever the same?