AFR Heads Crane Gold Rockers Geometry check
Hi, after running my engine for about 500 miles, I had a chance to take a look at the wear patterns on my Valve Stems. With the AFR heads and Crane Gold rockers and with what I had read recently, I am not sure if this is acceptable. During assembly I was pretty sure I had the correct push rod length best that I could tell. Luckily the lift is not too high, only .566 which may help.
Can someone who is way more knowledgeable tell me what you think. I have the best and the worst below in the pics. Most are in between these two.
Any help would be greatly appreciated.