Team Chevelle banner
Status
Not open for further replies.

350 block casting 3970014

203K views 12 replies 7 participants last post by  LeoP 
#1 · (Edited by Moderator)
Does anyone have an idea of what these blocks went in? The casting date is G 31 72. 3970014

It doesn't seem to be a very popular number. The heads have the camel humps.

thanks
 
#4 ·
Is the July casting date too early to be found in a 73 car?

Getting closer to finding out what this is out of. I found the stampings on the front of the block. T0929 CKD or CKL. last letter is hard to see.

curt
 
#11 ·
Is the July casting date too early to be found in a 73 car?

Getting closer to finding out what this is out of. I found the stampings on the front of the block. T0929 CKD or CKL. last letter is hard to see.

curt
With an engine assembly date of September 29th, it is for sure a 1973 model car it went into. :yes:
 
  • Like
Reactions: timjsmith1966
#5 ·
Here's all the selections:CKD 72 350 Nova 200 L-48 TH 350 4-Brl
CKD 72 350 Chevelle 175 L-48 TH 350 4-Brl
CKD 72 350 Camaro 200 L-48 TH 350 4-Brl
CKD 73 350 Nova 175 L-48 TH 350 4-Brl A.I.R.
CKD 73 350 Chevelle 175 L-48 TH 350 4-Brl A.I.R.
CKD 73 350 Camaro 175 L-48 TH 350 4-Brl A.I.R.
CKD 73 350 Camaro 175 L-48 TH 350 4-Brl A.I.R.
CKD 74 350 Impala 160 LM-1 TH 350 4-Brl A.I.R.
CKD 74 350 Chevelle 160 LM-1 TH 350 4-Brl A.I.R.
CKD 74 350 Camaro 160 LM-1 TH 350 4-Brl A.I.R.

CKL 73 350 Impala 145 L-65 T-H 400 2-Brl
CKL 73 350 Chevelle 145 L-65 T-H 400 2-Brl

July could be on the edge of 72/73.
 
#7 ·
I'll go get the vin on the front and see if there's one on the side. Just pulled the valve covers. The heads are 1966 462 matched. So I'm sure they don't go with the block. I'll put them in the classifieds.

curt
 
#8 ·
i had a 72 chevelle way back,original engine L65 350. it was a 014 block 2bolt with the same heads you have 462.Had no problems and ran the snot out of it on the street/drag strip for 13 years. 12.77et with 4.56gears.car went to NY.

Is there a chip in the lip around the oil filter area?
 
#9 ·
I'll look tomorrow. The motor sounds really good. I'm pretty sure the cam is not stock.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top