If you had to choose which parts you were going to rebuild your front end with (ball joints, center link, idler arm, tie rods, etc.) who would you go with?
ACDelco is a bit more expensive, but are they actually better?
Here's a some comparison pics of upper ball joints for instance:
I would go with the Moog parts. Despite what many have said, there is NOTHING wrong with Moog parts. Then you can use the other 75 bucks you would save and get some other suspension parts like and worn steering components perhaps.
napa sells dana and i would recomm it over both also!!! i chose it along with spc stage 2 kit,bilstein shocks and currie upper and lower in rear with del a lum front lower bushings in my stock lower control arms reinforced.
Napa's premium line has nothing to do with Moog. In fact the Napa premium line is not like any other suspension part anywhere other than Howe's precision ball joints. They are the best money can buy, no other suspension part manufacturer offers a one-piece socket with a precision forged and machined pivot ball, all the others are cast sockets and it's obvious.
Those Napa premium line parts are very good quality too. However, you wont have the 75 bucks left over to put towards sway bars. They are a little more expensive, but worth the extra cost none of the less.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Team Chevelle
5.1M posts
115.9K members
Since 1998
A forum community dedicated to Chevrolet Chevelle owners and enthusiasts. Come join the discussion about restorations, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!