Is it possible to wet sand out a run in acrylic urethane (single stage), and if so, what is the procedure?

Thanks,
Steve

Post your question hear http://www.autobodystore.com/cgi-bin/config.pl?index
They are very helpful..........Ward

If you have metalic paint NO. Non met, its possible if its not to bad. Its all up to your experience, I take 3 paint sticks and tape them togeather to make a long skinnie flat board to sand the run out. You have to sand on the absolute high side of the run untill it sands down to the paint level. Even at that chances are you'll still see it somewhat. But only you will know about it.

It's a non-metallic black, it's at a inconspicuous spot on my firewall. It might even be covered once the car is back together, but I'm not sure yet, thats why I am asking about fixing it.

Thanks,
Steve