i have a 66 elky parts car and would like to take a section of the roof and patch in my 66 malibu sunroof hole http://www.chevelles.com/forum/frown.gif anyone know if this will be possible? same contours??

------------------
1966 ChevelleSS LS-7/4spd
1966 Malibu 396/4spd
1971 RS Camaro 396/4spd

You could probably do it but personally I would just put a car roof back on at the factory seams. I see you ending up with a lot of filler by the time it is over if you just cut a section and weld it in. If yo do decide to go that way you might consider panel adhesive to do the attachment. The will not be the worry about warping the roof as much.

FYI the elco uses the front windshield and front roof the same as all 64/65 cars and 66/67 sedans only. If you have a hard top the front part of the roof is different.

Good luck....

------------------
78 Malibu (http://albums.photopoint.com/j/View?u=1261171&a=13240332&p=50222445)
still a terd but now with a new 383

67 Wagon (http://albums.photopoint.com/j/AlbumIndex?u=1261171&a=13352820)
project soon to be LT1 / 4L60E / 12 bolt posi daily driver

thanks for the info. just too bad someone had to cut it in the first place....

Gutz

------------------
1966 ChevelleSS LS-7/4spd
1966 Malibu 396/4spd
1971 RS Camaro 396/4spd