Just got a trunk floor from a 70 2 dr to install into my 71 and I noticed that the 70 did not have a vent type canister (for the fuel tank vapors I think)under the package tray like my 71 has. This replacement trunk pan is complete and I need to know how far forward to make the splice as I can not use the part that is missing the vent up under the package tray! Any advise appreciated!

[This message has been edited by 67johnny (edited 04-06-2002).]

Anyone done this kind of repair out there?

I'm not familiar with the canister hole your talking about.Can't you section right before you get to this point?

I know where you are talking about... That canister drops straight down, so you could technically get pretty close.. I would just cut out the bad areas and patch in new... but if you want too do the entire piece, I would cut too about 3 or 4 inches from the canister edge and splice there! Good luck!!!

------------------
X-Ray View of my Chevelle :D (http://www.normieschevelle.com/sideview.jpg)
Getting Closer (http://www.normieschevelle.com/passfull.jpg)