|
LS1970 Jul 6th, 05, 10:04 PM I have a 70ss with the idiots light package. I want to install the factory tach, amp,fuel and temp. guages. Can I do this without haveing to get a new harness and new circut board? Thanks, Dave - LS1970@aol.com undee70ss Jul 7th, 05, 6:01 AM Hers some info on the harness. http://www.chevelles.com/forums/showthread.php?t=55678&highlight=gauge Heres some more links on gauges and conversions http://www.azendrud.com/gauges/ http://www.azendrud.com/gauges/gauges.htm http://www.azendrud.com/gauges/lights.htm Also do a search on Elree Colby and Steve S in the Electrical & Wiring forum. They have many posts on gauges, conversions ect... Steve S Jul 7th, 05, 2:18 PM If you buy the aftermarket kit it comes with everything you need to switch from idiot light to gauges. Gauges, circuit board, wires for under dash and forward harness, temp sender and instructions. The aftermarket gauges are pretty close to originals, only difference I saw was the tach face has rivets vs 3 screws. The other issue I had was with the temp gauge calibration. For me the gauge seemed to track an original if the resistor was not installed. | ||