Guy at work is having trouble with extreme angle of pushrod for the clutch hyd cylinder on the firewall not being a "straight push" when connected to the clutch pedal. He says he can't raise the clutch hyd cylinder on the firewall enough to line the pushrod up correctly with the clutch pedal. I assume this is because of the brake master cylinder. I haven't seen this conversion but I know he drove it a few days before the trans gave up behind the sbc he installed. Any ideas ????? Thanks. Dave

go to www.blazinlow.com and look for zz4blazer. He is quite knowledgable about v8/manual swaps into the s-series. he has a zz4 with a 6 speed

Hey knudsonm, thanks much for the link ! Dave

I am Slow Ride on that site. I'm the local BBC swap guy.