haughty
Jun 22nd, 05, 9:33 PM
HI- I went and purchased parts for my "project" over the past few years. I have been reading the posts about good combinations/bad and now that I am about to start building from the frame up- I have questions.
I originally wanted to do the "junkyard" bit as it seemed like a good thing to do in the face of limited funds. Well, I didn't do it that way (saved and purchased by eating mac~n~cheese). I went and did some reading on the net and such- and ended up getting the CPP Classic Performance Parts 2" dropped spindles with 12" brakes and master cylinder with 7" dual booster.
I also did the 1.25" front sway bar, poly bushings, UMI rear trailing arms (non adjustable- as they weren't available at that time).
DID I TOSS ALOT of $$ - or am I going in the right direction?
THis is just supposed to be a nice driver- one that I would like to at least be safe and comfortable (public safety announcement , ya know) .... well, I''ll post the next set in a better forum, I just felt like this should be addressed first.
thanks everyone!
I originally wanted to do the "junkyard" bit as it seemed like a good thing to do in the face of limited funds. Well, I didn't do it that way (saved and purchased by eating mac~n~cheese). I went and did some reading on the net and such- and ended up getting the CPP Classic Performance Parts 2" dropped spindles with 12" brakes and master cylinder with 7" dual booster.
I also did the 1.25" front sway bar, poly bushings, UMI rear trailing arms (non adjustable- as they weren't available at that time).
DID I TOSS ALOT of $$ - or am I going in the right direction?
THis is just supposed to be a nice driver- one that I would like to at least be safe and comfortable (public safety announcement , ya know) .... well, I''ll post the next set in a better forum, I just felt like this should be addressed first.
thanks everyone!