i'm putting my front sway bar back on with new bushing and new brackets. i did not take a close enough picture when i took it off.i'm now having problems with the bracket holes lining up straight. they are close but i will have to pry them over. two questions 1. one end of the bar is round where it ties into the links the other end is square. which side of the car does the round end go on.2. after getting that part figured out could it still be put in upside down? i'm working on a 69ss. thanks gary

anybodys thoughts would be great,i need to get this back on.thanks gary

Gary,

I'm pretty sure the square end goes on the passenger side. With the bar flat on the ground the ends should be up in the air. Slidethe bar in making sure that the ends are resting on top of the lower control arms and loosely bolt the bar to the frame. The end link bolt gets put in from the bottom (nut on top) of the lower control arm. Then just tighten everything down.

'relic

james, thanks for the reply that's what i needed to know. gary