Just purchased a 4160 (600 CFM...single feed...vas secondaries)...for my 350 SB. Looking to replicate the attached single line fuel line set-up from the fuel pump to the carb. Looked high and low for the chrome hard line, bango fitting, SS line, etc..but can't seem to find it anywhere.

Any part numbers?

I grabbed this pic from the recent Engine Pics post.

http://www.chevelles.com/forums/attachment.php?attachmentid=422&stc=1

That is a nice feed line. Post your source if you find it.
I'll keep my eyes out for it too.

How about sending a PM to the original poster of that pic?

I grabbed the pic from 70chevelle15 and sent him a PM yesterday.....any body know this TC'r? I like the set-up, but again can not find it anywhere....custom bent piece?

I have that set-up on my car.It's made by Spectre.I bought mine at Pepboy's.

Hey guys, I thought I recognized that picture. Ya thats my set up. Like he said you can get them at pep boys or kragen. Beware though, check where they connect the line to the fitting. It just looks like they soddered it. The first one I got leaked because of a pin whole between there. I got another one and it was fine and it does look nice though. Good Luck.

Here's a link with some info as well as the part number:

http://www.powerflowracing.com/prtdetail.asp?PD=79

If you still can't find one, I do have an extra. It does have a small pin hole where leaked but you could easily fix it will a small weld or something.
-Brandon

Getting closer....thanks....on the Spectre link it notes the line but it shows a barb fitting going to the fuel pump?... as opposed to the threaded fitting from the picture??

Is there another variation?

Actually thats the same chrome piece. That picture is not of a fitting. All that is spectre stainless braided covered hose, and hose clamps with chrome covers over them. Ya so it's fake. Hehe fooled you. J/k. I think like 10ft of the covered hose costs $15 through summit and the hose cams are $3 for 2 clams and 2 covers. Pretty cheap but hey it looks nice and people always think that those are actual fittings. They do a good job of covering the clamps and it comes off looking very clean. All that stuff you can get at kragen or pep boys.

Ok...now that makes sense. I can't tell you the amount of Google searches I have performed to figure it out!!...thanks