Does anyone have a recommended air filter (paper type) part number for a 14" dia. 3", 2" and 2 1/2" height.

My new Glasstek hood is very well made and fits like a glove, BUT the center support hangs low and I need to use a shorter air cleaner and probably a K&N lid.

AC 212CW or Purulator equal

14 x 3"

Thanks Chris.

Tom,

I have to use a 2 1/2" x 14" K&N filter and X-stream lid under my 4" Harwood hood. A 3" (or greater) wouldn't fit on top of the Demon/Victor/HVH spacer. :(

Yeah,

I have a 1/2" poly spacer in there, it didn't help any with et or mph, so I will take that off and go with the 2 1/2" or filter with the extreme KN lid. I wonder why they don't offset the braces to allow more clearance. It wouldn't be that difficult.

Thanks

I tested a combo of spacers during the dyno session. The HVH showed the "greatest" improvement...meaning only 4-5 hp/tq gains at best.

I use the spacer (drilled/tapped) as a vacuum source for the tranny modulator valve.
None are provided on the Super Victor or the King Demon.