|
ETD66SS Jun 21st, 00, 1:01 PM I'm doing some patch panel repair on my 66 SS. I know there is some kind of rust proofing spray that I should put on the steel before doing any lap joints. What is it? and where do I get it? I could have sworn Eastwood had something like that, but can't find it in their catalog or , on their website! dselko Jun 21st, 00, 2:56 PM I could not find it on Eastwood's site either. 3M makes this product, it is called weld through primer. Any bodyshop supply store should have it and know what it is. [This message has been edited by dselko (edited 06-21-2000).] jimbuck Jun 22nd, 00, 5:06 AM I just got 2 cans. Stuff is expensive, $21 a can. Made by 3M. ------------------ Adam Buckingham 13 yrs old Jim Buckingham 72 Chevelle in Pieces WayneK Jun 22nd, 00, 5:43 AM One word of caution. shake the casn WELL and then skake it again. after spaying make sure you turn upside down and clean out tube/nozel, or you'll have an expensive paperweight. BTDT ARGHHHHHHHHHHH Wayne Kline ACES 1556 TCg | ||