What cam do you think will be best for this combo for a 3,600 lb. vehicle, th 350 w/2,800 stall and 3.73 gears. This will see alot of street time and some track time. Looking at these Hyd flat tappet Voodoo cams.

*** 60103LK adv. 268/276 @.050 227/233 .489/.504 LS 110/106 RPM 1800-6200
*** 60104LK adv. 276/284 @ .050 233/241 .504/.525 LS 110/106 RPM 2200-6400

406 zero decked with 10:1 compression
Dart Alumn Pro 1 heads 200cc 2.02/1.60 valves (mild port work) These are actual flow numbers:
Int. Exh.
.200 127 109
.300 208 154
.400 232 183
.450 250 191
.500 269 200
.550 277 203
.600 286 206
6" Scat 4340 H-beam rods
3.750 4340 crank (internally balanced)ATI balancer
SRP pistons
Edelbrock RPM Air Gap
Full MSD ignition
1 5/8 headers (want to maxamize torque)
750 Mighty demon carb
1.5 Harland Sharp rockers

Let me know what you think or questions you may have

You will definitely like the 60104LK cam and kit in your 10:1 406. You will need a good high-volume mech fuel pump and 1/2" #8 fuel line from tank to carb. Your combo should be good for 475+ BHP on conservative dynos, and depending on car weight, get you into the very low 12s or high 11s.

UDHarold

I know this post is a little old but my compression is actually at 10.43:1 and not the 10:1 I thought it was going to be. Error on my part. I guess I was wondering if this cam would still be ok that UDHarold suggested?

It will like anything up to 12:1......

UDHarold

Thanks