hey guys im looking for some place to buy a prepared crate engine for a twin turbo setup..

i mailed theengineshop.com but still no response..
lingenfelter is just TOO pricey...

any other place to look at?

Thanks!

you might want to try banks i know they make kits for a small block chevy, but im not sure if they make full carte motors i think they do. the small block twin turbo kit it tuneable to 1100 or so HP on pump gas. hope this helps you out

yes they make crates but with full kit for about 40k

no way.. and well i have allmost all the stuff needed, i just need the prepared block..

i tried with Bill Mitchells shop because i would love a 427 small block...

see what you think... http://www.strokerengine.com/strokerengines.html

see what you think... http://www.strokerengine.com/strokerengines.html


woa..im mailing them, thank you!

You're welcome!

Before you get all squidgy about a turbo stroker, you should be aware that a proper blower piston will have its ring package further down from the crown. This will directly conflict with the stroker piston pin location. What you want is a bullet proof 350 short block, with moderate size heads.

i want a 427 Twin Turbo.

Thats what i want, im looking for someone to build the block.

i not need it to be a stroker.

A 427 is a 400 block with a 1/4" stroker crank, and usually 6" rods.

maybe but i need a bock capable of holding 20psi+ with a 4.125 bore / 4.000 stroke.

So your goal is roughly 1200 to 1500hp then?

thats optimistic, but i hope to reach 900/1000 on pump gas..

if i can reach 1200/1500 on race gas i would be MORE than excited..

You don't need 20 psi to reach your goal of 900-1000 HP, which I think was the point that TJC was trying to make.

Jody

excellent then, 1200 here we go ?

:D