I think we figured someone put 78 up monte brake in the front of my chevelle, I installed the motor trans the other day and went to hang the fenders last night, with the car on the ground with wheels the tops of the tires look like thay tilt out too far. I put a big block on small block springs, so pulling up on the front end seems to pull the top of the tires in, but do using the g body spindle cause this problem? It looks like I have enough adjustment by stacking about a inch of shims or cutting a spacer, I also have stock disc brake spindles I can put back in the car if I have to but I kind would like to use whats on the car now just to drive it when it's ready has anybody run into this before? I'm basically trying to keep cost down (HA HA) Jim