has anyone used the full width trunk floor from npd? if you have i need to know how far up the front and back lip go. if possible can i get some pictures. thanks, chris

Come on, doesnt anyone here have an answer to this post. Im kinda in a spot on thisone.
Thanks Chris

------------------

What pan are you talking about?...the 1 piece non ups able floor or what?. I havent used that 1 piece myself but know others that have and in the front the line ended about 1 inch below where it starts to go horizontal. Also in the back it ended just short of where it goes horizontal. Also it didnt go all the way to the trunk ext or filler panel, the piece that connects the quarter to the trunk floor.

I used the two piece design from NPD and was very happy with the fit and finish of floors. In the front it extended well over the top of the shock mount area where they always rust. And had more then enough room in the back. It also went all the way to the quarter exts. I had great fit around the inner wheel wells and exts. There was some minor trimming in the back of the floor and alittle metal reworking of the lip where it meet the exts, it just needed to be bent around the other way or turned 180 degrees.

I have pics that I can send of the two piece floor and how it fit and where I had to my metalworking to get it to fit...Eric

thanks, if you dont mind could you send me the pics you have. I need it to at lest go over the top in the front and the back. the pan i was talking about i beleive is new but they say it goes from filler panel to filler panel, they just dont tell you how far over the lip they go. i was wanting to find a good trunk floor out of a parts car but to no luck so far. thanks for the info.