Finally did removed the undercoating boy what a mess around 20 hours to do. First used propane torch and scraper to get 80% off not to bad but that stuff is hot when it lands on you :o . Then went at it with a angle grinder and a wire brush to clean up a get rid a rust but it looks good now. Quite a few showers and a few wire brushes only thing I found it pays to get the better wire brushes they last way longer.

Isn't it fun?!?!?!!!???

I just primed the last section of my undercarage... I know first hand the fun you had.... I was lucky, & had little to no undercoating, just in the rear wheel wells... I just had ALOT of red clay coating the bottom of my car, it did a GREAT job of preserving it though..

All I can say is that I am really glad that its done..

Scott