Here is a picture of my car sitting outside with it ,s wheel on. I,m going to wait till every thing is in it and then see if I need to lower it.
Right now it looks a couple inches high.. I have 245/60/15 in the front, and 265/60/15 in the rear. http://img67.exs.cx/img67/7027/67ssoutsidepictures0033ay.th.jpg (http://img67.exs.cx/my.php?loc=img67&image=67ssoutsidepictures0033ay.jpg)

Does LOOK kinda high dosn't it?? Maybe with the interior and drive train installed it will drop a bit but I wonder how much?


Tazz

It has all that in, just need fender wells trim and interior, OH I had the Bumpers sent out to be rechromed, should be in any day...Still will probably cut half a link on the springs and go from there. The rear I can take out the spacer plates...

Just another opinion....I have 14" on the front and 15" on the back. I think it sits just perfect. :cool: Yours almost looks like it hasn't got a motor in it....If it were mine, I'd for sure lower the front.

I know, Itold my body man that I am not happy with it being so high, The new springs and shocks a really tight, I don,t think it will settle even close enough to where I want it.
When it,s done, I,ll have them do the changing, need to put 3.73 gears in the rear end then also. have to run it down the hiway 40 miles for someone to do it...My bumber better be in next week, this was the 6th week they said would be done, had them rechrome out in Minn...

big block will lower that car down just fine!!!

I have a 396 BB,800 Holley, Completely redone to the Max, Racing Heads , ect, But went with Factory exhaust Man., and 2 1/2 inch FlowMaster exhaust.
Was really going for Headers, but got talked out of them because of the room to work with..Oh Well, can always change do the road.. smile.gif
Talk to my Machine today about lowering, will lower the back slightly , the from at least a couple inches.. Does look like there isn,t any engine in it, doesn,t it?? smile.gif