Finnaly figured out how to make this damn thing move manually(my elec motor is dead) and was able to move it & access the rear bolts.

I thought I would post instructions on how to manually move factory power bucket seats for future reference.

There is a small cover on the front edge of the seat inbetween the tracks- this covers the belt drive. There are two small screws holding it on.
Remove that cover
Remove the Belt and the Left pulley
Behind the left pully are two small square openings- These are the opposite side of the cable drive mounts.

Insert a #3 square head bit into your drill
Put the bit into one of the square openings- and slowly go forward or reverse.

On my seat the Left Square was for forward & back and the Right square was for up and down.

Assuming your sliders are not the problem, this will move the seat with no problem.

Hope this will help someone else someday!
graemlins/beers.gif

Good tip! I know many people have trouble with their power bucket seats when they are not working. I am lucky I bought one for cheap, and it works.