What is the best route to go when replacing an entire trunk pan including braces? do I go for the 2 piece, or 3 piece? Pro? Cons? I need a pan that will go up and over a little bit onto what I guess is where the rear end sits under. Package tray maybe? It's the flat surface that ends at the back of the rear seat. Thanks in advance.


Shay

Yenko, if you look that this pic you can see where a 2piece pan comes up.
http://briefcase.yahoo.com/bc/sevt_chevelles/vwp?.dir=/70+Chevelle+Project&.dnm=Test+fitting+new+trunk+floor.jpg&.src=bc&.view=l&.done=http%3a//briefcase.yahoo.com/bc/sevt_chevelle s/lst%3f%26.dir=/70%2bChevelle%2bProject%26.src=bc%26.view=l (http://briefcase.yahoo.com/bc/sevt_chevelles/vwp?.dir=/70+Chevelle+Project&.dnm=Test+fitting+new+trunk+floor.jpg&.src=bc&.view=l&.done=http%3a//briefcase.yahoo.com/bc/sevt_chevelles/lst%3f%26.dir=/70%2bChevelle%2bProject%26.src=bc%26.view=l)

It doesnt come near the rear seat, so if you need more you are going to have to go a junk yard. A pro for the 2 piece a lot less welding, only one seem to weld shut vs 2 seems. Plus I think it would be alot less headache fitting the 2 pieces together vs fitting 3. I know my 2 piece from paddock fit real good. A pro for the 3 piece would be that the braces are preweld on the 3 piece but not on the 2 piece