|
fatlip Jan 25th, 02, 6:11 PM Hi people,have a question again.I have a speed demon carb,650,,has 2 electrical clips on electric choke,where is best place to get hot and ground for this carb.I have a hei ditributor,its a new ho 350 engine. Thanks again, Rick riskyvt Jan 25th, 02, 8:06 PM Rick- This is pretty simple....a 12V source must be connected to the (+) choke terminal. Run a wire from your fuse block at a port marked IGN. Verify that the spot on the fuseblock is HOT only when the ignition key is in the "on" position. Then run a ground wire to anywhere on the engine from the (-)choke terminal. You can use one of your carb mounting studs/bolts to make a ground. Good Luck! ------------------ Gregg Haskin 72 Chevelle SS ZZ502 Crated RAT Muncie M-20 4 speed TEAM CHEVELLE #726 ACES #4486 "PROUD TO BE AN AMERICAN!" “What the heck are all these extra nuts & bolts for?” My 72 Chevelle SS Restoration Website: www.wcvt.com/~ghaskin (http://www.wcvt.com/~ghaskin) odie Jan 26th, 02, 1:24 PM On my Holley, the ground wire is only about 2 to 3 inches long so I mounted it to one of the screws on the side of the carb (mounting screw for a bracket. It will ground through the carb body via washers & nuts (or bolts). Just in case your wire is short like mine was. Good Luck & enjoy your Demon. Odie | ||