Just purchased a factory AM radio for my 67. Unfortunately the radio plug has been cut from my wiring harness. Could someone help me out by telling me what each terminal connection on the radio goes too!! The radio has a 3 terminal plug and it also has what appears to be a fader control under the tuning knob with a three wire small connection at the end. Thanks, Mike

P.S. Anyone got a radio connector from a junk harness they may be able to help me out with??

[This message has been edited by m22chevy (edited 01-28-2002).]

Mike, I have a '67 radio and harness assembly with the fader control. Your radio has a 3 terminal "socket" in the lower right corner.(looking at the rear of the radio) These terminals right to left are 1)speaker black wire 2)speaker light green 3)12 volt power yellow wire.
The speaker wires black and light green come from the speaker and have triple plug that plugs into the radio. The yellow wire comes from the car's underdash harness and has a plug that plugs into the third space in the speaker harness.
The fader control is plugged into a rear seat speaker harness that "jumpers" between the radio and the front speaker three terminal plug. This rear speaker harness is NOT necessary if you want to just use a front speaker.
Sounds confusing.....E-mail me if you want more info. Tim

------------------
Tim
'57 210 2Dr Wagon
'67 300 Deluxe 2Dr Sedan
'72 SWB Orig 402
'81 El Camino TPI 4-speed

Hey Tim!
Thanks very much for the info! So as I see it the first two terminals from the right go to the dash speaker, the third terminal is the yellow 12V + which I have found in my harness. I would imagine the radio chassis must be grounded for it all to work! Mike