i am currently putting an edelbrock 2411 .750 cfm electric choke carb on my big block, what would be the best route or way to wire this up ?. thanx for any advice , mike

i just route mine through the fire wall, under the dash into the fuse block. I have have heard of people splicing it in w/ their windshield wiper motor too.

------------------
1968 Chevelle malibu w/ 327 bored .030 over, TH350 w/ shift kit
MyChevelle (http://www.cardomain.com/member_pages/view_page.pl?page_id=252044&make_type_query=make%3DChevrolet&model_brand_query=model%3DChevelle&tree=Chevrolet%20Chevelle)
12 bolt w/ 3.73's

Mine have worked fine on the Ign circuit(coil) or other switched circuit in the engine compartment.

Don't tie it to the (+) coil if the original resistor wire is still being used. The voltage is too low on that terminal.