|
: Converting from column shift to floor shift lance-w Aug 30th, 02, 1:29 PM Is it possible to modify a steering column that was originally set up for a column shift to be a floor shift column by just taking the parts out of it? I realize you would still have the whole where the shifter arm exited the column. As you've geussed at this point I have a column shift that's going in a floor shift car. Lance 1966_L78 Aug 30th, 02, 1:42 PM Depending on the year, I don't think you even have to remove the internals... You can cut off the bump where the shifter attached, and either weld a piece in, or try to Bondo it closed... Maybe some of the later Chevelles might have a problem with the ignition switch, as I think there is linkage that will not allow the key to turn unless in a certain gear (Park, Neutral for and Auto, maybe Reverse for a stick?)... ------------------ "Once you go RAT, you never go back..." TC #1366 Tony http://www.chevelles.com/showroom/Quik66.jpg http://www.chevelles.com/showroom/eng7.jpg lance-w Aug 30th, 02, 1:45 PM It's a 66 column. So no ignition problems. | ||