I know there are a ton of posts on bucket seat but I realy didn't want to read them all. Which back hole should I use, the inside or the outside. It's for a '67. THANKS!!

Mine would only go on one way. One was inside and one was outside?????

I'm sorry I should have said I'm converting a bench to bucket. I have to mount a bracket for the right side and want to get the left side in the correct spot.

I'm doing the same bench to bucket conversion, and I just got the brackets from Ground Up (although the packaging says Original Parts Group!). I was disappointed to see that they were pretty rusty right in the package, but that's not my point. I haven't gotten into it yet, but how do these brackets install?

What I did...
I took the bracket and bolted it onto the seat, (outside of the car) I then put the seat in and lined up with the center of steering wheel and bolted in the closet bolt hole. Then welded the other side (bracket) to the floor.
Hope I made sense graemlins/beers.gif

Thanks Wes, I get what you are saying. Did the brackets go on the inboard or outboard side of the seats? It may be obvious once you look at it, but I just haven't had a chance to yet.

I should read more. I see that Rich L-79 has just answered my question in another thread. Inboard side!