Hey Guys and Gals,

I bought a new dash bezel for my 67. It's the long cover that goes on the upper dash that the ignition switch, headlight switch, etc mount in. I have two problems with it.

1. The original had studs mounted to the bezel and was held on with nuts. The new one has screw bosses and is held on with the same fittings that hold on the glove box bezel. The problem is, it did not come with any mount hardware. Any ideas of where to get some?

2. The various switch bezels are all molded into the new part, whereas the old part just had open holes and the bezels are what held the switches in. How am I supposed to mount the switches? The molded in bezels are in the way, and no alternative mount hardware was included.

Anyone out there have any ideas?

Thanks