On a '70 Malibu, can anyone tell me what the size and thread pitch is on the 2 bolts that hold the back of the rear seat in place? They screw into 2 little welded brackets down near the bottom edge of the sheet metal behind the seat back. I'll be danged if I can find any bolts that fit!

I KNOW somebody on this list knows exactly what they should be.

Thanks folks, and Happy New Year!

------------------
Mike Ahlmann
'69 Elky SS-396
Sunnyvale, CA
There are no atheists at 150 MPH!

Mike,

These are NOT a standard machine screw, so I don't think thread pitch applies here. They are like a large sheet metal screw with a hex head (7/16" or 1/2", can't remember which) and a large diameter attached washer.

------------------
Bill Pritchard
69 SS396 Convertible
"Life is short; eat dessert first." - Ogden Nash
My low tech web page (http://home.att.net/~bpritchard/wsb/index.html)

[This message has been edited by Bill Pritchard (edited 01-07-2003).]

Thank you very much. That's just what I needed to know.

------------------
Mike Ahlmann
'69 Elky SS-396
Sunnyvale, CA
There are no atheists at 150 MPH!