I am looking for a 90 degree fitting that goes on the left side of an edelbrock intake manifold to go to the heater core. The problem is that the one that I found sits to high and the fuel line fitting going into the carberator hits. Does anyone know where to get a lower fitting. The help would be mucha appreciated.

The manifold is for vorteck heads and the engine is a 350 cid.

Autoeez,Can the fitting be chucked in a lathe and turned down or otherwise (check local machine shops).Can you install a minor carb spacer to gain clearance...have you been to Gotelli's Speed Shop ! (I sure spent $$$ there when I was a younger lad !)

------------------