I discovered the dimple on the hood on the pass side where the hose goes, but no retainer. Thanx Big Man!
Anyone know the P/N for this thing? I also need a longer vacuum hose from the carb to the vacuum actuator. What is the correct size and length of the tubing?
The vaccum pod connector point toward the engine, so it may be original.

------------------
JARRET GRATHWOL
TEAM CHEVELLE MEMBER #573
1970 Chevelle SS 396/ M-21
You can see my Chevelle SS here:
http://www.geocities.com/stangsvt99/Jarret_s__70_Chevelle_SS.html

I don't know the GM part number but its listed in my Classic Muscle catalog as a vacumn hose retainer, part#4382GM. The line should be 1/4". Cut the length to suit, start long then shorten as needed.
This part may also be available at the site's sponser Ground Up, if not try Classic Muscle from Modern Chevrolet, 1-800-722-4828

------------------
Life aint easy when you're fat and greasy!

Jarret
The vacuum line hose retainer is the same kind used along the drivers side inner fender.It is plastic about 2"long with a tooth on each end.It holds down the front end harness and wiper/washer rubber hose line.Very common at any auto parts store.

------------------
Rick Peters ACES#175
1970 Red/Red Chevelle SS
L-78/M-40/4:10 Restored

Big James is right on! Classic Muscle has them in a package of two...$3.00, ordered mine today.

------------------
Chevelles forever....Member #401

[This message has been edited by 67SS509 (edited 11-09-2000).]