I would like to mount my regulator at the carb using one of these plates.

The carb is a 4500, Dominator and all the plates that I have found so far are for standard flange carb.

Do you guys know of anyone that makes these plates for Dominator carbs?

Thanks

hey if its like the plate that mounts a holley regulater that Edelbrock sells it should be easy to make yourself.

Make one ! http://image1ex.villagephotos.com/pubimage.asp?id_=1222685


I wanted one to hold two regulators, throttle switch, cable linkage mount and N2O solinoids. Of course its hard to find off the shelf. So I took a sheet of aluminum traced the gasket out line on it and stared adding everything I wanted. With some simple hand tools I had it drawn, cut and installed in a few hours. Alot cheaper too !



[This message has been edited by roger69 (edited 12-22-2002).]

Thanks guys, maybe I will give it a shot.