Can't seem to keep the right upper w/shield molding on. Met a semi and it blew off and of course the next oncoming car ran over it. Znybody got one? And any tips on putting it on? I did use new clips. Thanks

------------------
Steve

Steve, if you had new clips and the old molding still blew off, chances are the molding was deformed in such a way as to fail to grip the clips. When you get a replacement, make sure all clips are pushed fully down over the studs, (they should hook under the stud so as not to pull off) then make sure they spring towards the vertical part of the channel, just touching it. Finally, when you (gently) press the molding into place you should hear it "click" when seated. No mallets!
Hope this helps,
Rich