I think this site should have a "Fabrication" section, a place where all of the welding/bending/fabricating posts could go.

We have a lot of very talented fabricators on this board and they should be given an opportunity to show off their skills.

It could also be used for tech questions that don't really belong in any of the sections that we have.

Thoughts?

It could be added to the Tools and Shops forum, as that already exists and does not get a huge amount of traffic. It might be re-named as Tools, Shops and Techniques.

Don't forget folks, Al is gone and he's is the only one that cared AND could do it.

It could be added to the Tools and Shops forum, as that already exists and does not get a huge amount of traffic. It might be re-named as Tools, Shops and Techniques.
I support that.