stuipid question, but here it is. what bolt pattern fits the 71 chevelle? The bolt pattern is the same as the stock one, but I don't know what that is. I am kinda far from the wheels and the car so I can't go out and measure it, so a simple answer would suffice. Just want to get the right size to replace the wheel that is FUBAR due to an accident (Not my fault).

5 on 4.75"

Thanks a lot for the quick reply. It turns out it doesn't matter all that much because I am have the Cragar S/S wheel, and it is "multi purpose" in that it can fit either a 4.5 or a 4.75 bolt pattern. Just sent my brother out to measure the back spacing, and I'll finally get to order the replacement wheel. Also anyone got any ingenious ideas of something to do with a bent wheel? (barstool or something?) I would like to do something creative with it rather than just scrap it.

I have a cool waterhose holder made from a 1992 Corvette 17x9.5 wheel.

i have a impala ss 17x9 (i think) that i convereted in to a small glass table. put a used tire on it, laid it on its side and put glass top. had to make spacers to raise it off the ground a little though.