Does anyone have the "rough" opening between the fenders. I want to aligh the fenders now so hopefully the hood will have minor adjustments. Any dimensions on an angle between the fenders to make sure they are square? Thanks

Does anyone have the "rough" opening between the fenders. I want to aligh the fenders now so hopefully the hood will have minor adjustments. Any dimensions on an angle between the fenders to make sure they are square? Thanks

You won't need measurements, the rear of the fenders must align properly to the doors.
An X measurement between the two sides will say if they're square.

Well, if you have the hood your going to use, you can simply measure it's width and add 3/8". This will give you approximately 3/16" gap on each side. I use a wooden paint stirring stick to check the gaps.
That said, my hood it currently off and the dimensions inside the fenders where the hood gaps are measures 56 13/16" front and rear. As mentioned above, make sure to take diagonal measurements which will be equal to ensure its square.