i want 15x10 wheel's in the rear but i can't really find any that will look good. i don't want them to be expensive. like under $200. i am just having no luck finding a wheel that has 5.5 inches of back space and eather doesn't cost a fortune or dosent look butt ugly. so please give me your suggestions and where i could find them if you can.

thank you

It all depends on your taste I suppose. Weld Draglites 15x10 with 5,5" backspace are around 165 each. once you start getting into the bigger sizes, you either get cheap and ugly, or pretty and pricey. Maybe try looking at swap meets, sometimes you can find good deals on wheels there.

------------------
Steve Beuth

69 Malibu ZZ4-350
79 Trans Am
93 Camaro Z28
99 Silverado
Chevelle pics (http://hometown.aol.com/zz69chevelle/myhomepageauto2.html)

Plan for the worst, hope for the best.

Ya good luck finding 15x10's with 5.5" backspacing, I think our cars are pretty much the only ones that needed that combo.

I looked and looked, ended up buying new. Sure it cost a lot (each mag was about $200usd) but damn they look good. I have the 15x10's out back too.

http://www.rblords.com/images/audio/c1.jpg

------------------
Chris Dagenais
Saskatchewan
'71 Malibu with a home built 454!
"Salad and vegetables are what food eat!"
My Page (http://www.ycworld.net)

http://www.adam_nova.homestead.com/files/side.jpg

http://www.adam_nova.homestead.com/files/rearside.jpg

15x10 5.5" b.s. -- $63 from summit, just tell them you need 5.5" of backspacing, they will special order them at no extra cost, takes about 2 weeks.

BTW - They are U.S. Wheel series 37. The fronts are 15x7 with 3.75" backspacing.

------------------
1971 Chevelle Malibu - 406 sbc TH350

Pic of my car (http://www.adam_nova.homestead.com/files/frontside.jpg)
another picture of my car (http://www.adam_nova.homestead.com/files/side.jpg)
Picture of my 406 (http://www.adam_nova.homestead.com/files/enginein.jpg)
Picture of my and my buddy's '65 4-4-2 (http://www.adam_nova.homestead.com/files/meandryan.jpg)
My site (http://www.adam_nova.homestead.com)

[This message has been edited by AdamLym (edited 06-22-2001).]

[This message has been edited by AdamLym (edited 06-22-2001).]

hit the swap meets, i always see 15x10 with 5.5bs. in just pairs, then save some $$ and buy the front runners to match, im of course talking about weld drag-lites http://www.chevelles.com/forum/smile.gif

------------------
1970 SS396 AKA 454/4spd
My Chev-Hell Page (http://hometown.aol.com/jnkb2cool/home.html)
Member #783
Ft.Worth, Tx
Big Block Chevy.net (http://www.bigblockchevy.net)
proud owner of this site
(OO=ss=OO)