hi i have never posted on here but have come for a lot of advise i could not find anything on replacing the cowl and window channel on a 70 chevelle i just did it on my car with the dyna corn lower cowl and corners they fits awsome now i still need to do quarters i found some on ebay that are old goodmarks but they want 1k each are they worth it or will the newer stuff work just fine and which of the 2 are better dyna or new goodmark let me know i have lots of work ahead of me still any help would be great

I'll be installing a lower cowl panel and windshield channel this weekend. I will take pics as I'm doing it.

i finally just bit the bullet and put mine in i wanted to let everyone know how they fit cause i saw a lot of questions on how they fit and noone really had an answer when doing yours just be carful when you get to the edge of the fire wall it tears real easy and has a few spot welds hidden behind the fender mount on the fire wall and a ton of them around the wiper motor i should have had my camera out there with me while i was installing it but once the old one is out the new goes in nice and the aftermarket even had the wire harness tabs already welded to it really nice piece for a repop if i could figure out how to post pics i would put a couple on here

Welcome Rob! Just go to www.photobucket.com and upload pics, then you can copy them to here!

I just did some: http://s223.photobucket.com/albums/dd55/rorydog69/?action=view&current=DSC00261.jpg

i think i have it figured out

I'm not doing the cowl sides too..they don't need to be replaced...just the lower cowl panel. I also have to install a firewall section too. I looked on a junk one I had here...seems pretty straight forward.

im not sure how hard it is going to be with both corners on they overlap onto the lower cowl on each side but good luck and have fun ive never done any body work untill i got this easy drop a motor and tranny in car yeah im sure weve all had a few of those has a lot of ss stuff so i pulled the back seat looking for build sheet found bad floors covered with duck tape and just went from there now its going to be a total resto and still havent found a build sheet