danielk
Mar 2nd, 10, 5:44 PM
I just purchased a '64 Malibu SS that had all new sheet metal installed, so I have no holes to use as guides for my new emblems.
Does anyone that has a '64 have a few minutes to possibly measure emblem location on the fenders - "Chevelle", Flags, and "Malibu SS" locations? Fenders only are needed.
Thanks!!
Daniel
spinshop
Mar 15th, 10, 10:07 AM
I just purchased a '64 Malibu SS that had all new sheet metal installed, so I have no holes to use as guides for my new emblems.
Does anyone that has a '64 have a few minutes to possibly measure emblem location on the fenders - "Chevelle", Flags, and "Malibu SS" locations? Fenders only are needed.
Thanks!!
Daniel
Daniel,
I just read this thread,if you are still looking for pics
I can take some with measurements.
Les Saville
Mar 16th, 10, 12:43 PM
Also you can find all that info in the assembly manual.
Rich-L79
Mar 16th, 10, 3:48 PM
Also you can find all that info in the assembly manual.
Are you sure about that? Emblem locations are not outlined in the '65 AIM. I believe this is because the emblems were installed by Fisher Body, not by the Chevy assembly plant.
danielk
May 19th, 10, 10:17 PM
Only limited info in the assembly manual. I found some pictures that helped.
Thanks!