Does anybody out there have a picture of the location of the factory floor brackets for a powerglide or TH400 console? Also, the factory cutout for the shifter linkage. Thanks.

the difficult part is going to be the reference mark. it is hard to find a good ref point such that whatever measurement you get is based on a specific reference point and will be difficult for you to translate to your specific floor. this is particularly true if others (me) replaced the floor so i cannot reference to a specific original line. when i replaced my floor, i made a random mark on a very small section of the original floor which i was keeping. this was very helpful. i still have my floor accessible so i can take pics and measurements but I need have a specific ref point for measurements. if you'd like send me pics of your floor to see what i may be able to use as a ref point. i have a 67 w/pglide tranny.

Thanks for the reply. I'll take some pics. tomorrow. In the meantime, is it possible to see pics. of the factory cutout for the shifter linkage? I really appreciate your help on this.

Does your car still have the factory floors in it?

i uploaded some pics here. http://s848.photobucket.com/albums/ab41/malibu67/

note where i scribed a mark on piece of original floor which i kept. from there i measured to hole. from front to rear, it shows front bracket for console, shifter hole, 4 holes on flat section of floor and then rear console bracket.

It still has factory floor.

i uploaded some pics here. http://s848.photobucket.com/albums/ab41/malibu67/

note where i scribed a mark on piece of original floor which i kept. from there i measured to hole. from front to rear, it shows front bracket for console, shifter hole, 4 holes on flat section of floor and then rear console bracket.

Thanks for the pictures!!