I need a couple of measurements please that I have drawn in red at the rear of the trunk pan:
http://www.chevelles.com/showroom/data/500/591.JPG
The cut at the rear of the trunk panel I got from a donor is not even. i want to make sure I'm good where I have the pan sitting.
Thanks!:beers:

The picture in my previous post is not of my car, I'm just using that as a reference. I need someone to measure the two area's to see if the rear of my trunk floor is sitting correctly height wise. I believe it is but want to make sure. The problem I'm having is that I can't get the floor to butt up completely across underneath where the braces weld to the rear panel. It butt's up nice from the passenger side to about 2/3 of the way to the driverside. I can't get it to butt up close enough to feel comfortable to weld. The rest of the pan seems to be aligned nice, just can't figure out why the rear won't butt up completely:(. The rear section that the trunk floor welds to is in nice shape. I appreciate any help.