Couple questions for you experts for my 70 BB (non A/C) -- will be hooking up TCS btw. I looked through the AIM but need alittle more explanation regarding some of the wire clips.

- Appears the heater box has 2 clips. 1) Bottom right which the engine harness feeds through as it branches out to the TCS and to the starter, etc. 2) Bottom, 2nd in from the right which supports the orange power wire for the heater box. Is that the correct routing for those wires? Also is both clips this one?
http://www.ss396.com/mm5/merchant.mvc?Screen=PROD&Store_Code=chevellecamino&Product_Code=AHB-1X

- On AIM Page 49, there is a clip on the firewall that appears to have the washer hose running through it ... does the Engine harness route through there as well as it turns to go towards the passenger side of the car? Is this the same clip as used on the heater box or another? Lastly, anyone have a good pic of this clips location, was kinda hard to get a good idea on the manual. Appears to be top right of the Brake Power Booster...

- Any other clips I'm missing on the fire wall to properly run the wires?

- Besides purchasing the expensive valve covers from Crane Corvette, is there anyone that has the wire clip for the temp sending unit wire?

- Almost forgot .. Page 49 also shows a clip that is used for the Drivers Side washer squirter hose .. after it feeds into the cowl there appears to be a clip holding it. Anyone have a pic of how it mounts and also what clip is utilized for this?

I just got clips on the brain today :)

Happy Thanksgiving!!! I get to work on the car and my wife cooks the bird .. loving it!

Dave

Couple questions for you experts for my 70 BB (non A/C) -- will be hooking up TCS btw. I looked through the AIM but need alittle more explanation regarding some of the wire clips.

- Appears the heater box has 2 clips. 1) Bottom right which the engine harness feeds through as it branches out to the TCS and to the starter, etc. 2) Bottom, 2nd in from the right which supports the orange power wire for the heater box. Is that the correct routing for those wires? Also is both clips this one?
http://www.ss396.com/mm5/merchant.mvc?Screen=PROD&Store_Code=chevellecamino&Product_Code=AHB-1X Yep that is correct.

- On AIM Page 49, there is a clip on the firewall that appears to have the washer hose running through it ... does the forward lighting harness route through there as well as it turns to go towards the front of the car over the Wheel Well? Is this the same clip as used on the heater box or another? Lastly, anyone have a good pic of this clips location, was kinda hard to get a good idea on the manual.No the clip is for the engine harness going over to the passenger side.

- - Any other clips I'm missing on the fire wall to properly run the wires?.
Nope.
- - Besides purchasing the expensive valve covers from Crane Corvette, is there anyone that has the wire clip for the temp sending unit wire? .No thats welded on them.

Thanks Ron. So the clip for the engine harness is that the same clip as the heater box clips?

Also, anyone know which is the correct bolt from AMK for the clip to the firewall (couldnt find it) and I'm looking for the 3 bolts that screw in the Clutch Rod Boot retainer, not sure if its: G-5740 STEERING COLUMN SEAL RETAINER HXWA AB SCREWS, HX AB CONI SEMS 7 pieces


Thanks,

Dave