I'm installing a new clutch/pressure plate and I'm wondering what the figure is for torqing the pressure plate to the flywheel? Or is it just a "good snug"?

Buy the way, I'm using ARP pressure plate bolts.

I'm installing a new clutch/pressure plate and I'm wondering what the figure is for torqing the pressure plate to the flywheel? Or is it just a "good snug"?

I would ask the people who made the bolts.

But you can look on their web site and you will find that for a 3/8 24 200,000 pound bolt the torque is 49 using the correct lube.:thumbsup::thumbsup:

That's so crazy, it just might work. While waiting for a reply here, I did just that and found what I needed. Thanx much.

Stock type GM pp to flywheel bolt trq is 35ft lbs.

Stock type GM flywheel bolt to crank trq value is 65lbs.

I use some locktite for these apps.

Those trq values were per GM manual with stock GM bolts,not for ARP bolts with arp assembly lube which will be different.

Scott

That's so crazy, it just might work. While waiting for a reply here, I did just that and found what I needed. Thanx much.

It must have been really bad, waiting 17 minutes for a answerl:)

I would have done the same thing, looked on the ARP web site:rolleyes: