Hey guys,

New covers going on my '69 buckets and the current covers are non-'69 so I don't have any reference to the locations of the 2 buttons for each bucket or the rear bench. To clarify, I am refering to the upholstery buttons on the front of the seat, not the release button on the back.

Does anyone have any pictures of and/or ideally any measurements as well?

Thank you all for your time.

Buttons are just shy of 8 inches down from the top seam with the tape following the the contour. 7 7/8 inches to the center line of the button.

http://lh5.ggpht.com/_aZniZlzG90Y/SMEfse3q4VI/AAAAAAAAA5w/HicCzp8qOco/s512/S7302184.JPG

http://lh6.ggpht.com/_aZniZlzG90Y/SMEgRpXOSiI/AAAAAAAAA9A/WUWPZ3ogd2o/s800/S7302209.JPG

Dan

The new covers dont already have the buttons already on them?

The new covers dont already have the buttons already on them?

:noway:

The new covers dont already have the buttons already on them?

Nope, included, but packaged seperately.

Thanks for the info and pics Dan.

Are you not running headrests? Thinking about leaving mine off, they're not in very good condition, niether are the bezels and associated hardware.

THanks again.

I like the pure dangerous look of the seat w/out the headrest.

Dan

Ok guys,

Got the buckets info from Dan, can anyone address the buttons for the rear bench?

?

Hi Joe, I have new Legendary covers for my 69 still in the plastic. I can take a pic if you like as they come with the buttons on them. Phil

I'll try to get the measurement from the back seat of my Malibu. Be later on today...

Dan

:noway:

Nope, included, but packaged seperately.

Thanks for the info and pics Dan.

Are you not running headrests? Thinking about leaving mine off, they're not in very good condition, niether are the bezels and associated hardware.

THanks again.

I never knew that so ill have to keep this in mind for my 69 down the road. How do the buttons attach from behind then?

Legendary Auto Interiors covers do have the buttons already installed.
Otherwise, you would poke a hole in the material and spread out the metal mounting tabs.
Even though my buttons were already installed, I took some HD glue and some Gorilla tape over the tabs to make sure they weren't going anywhere.

Dan

Back seat buttons are 10 inches down from the back edge, the tape bends around the seat back. Measures 14 inches up from the bottom edge.

Dan

The last set of new covers I seen were for a 69 and they had the buttons on them already. Which is what the line of thinking I had aftering seeing them in the packages.

Hey guys, thanks for all, . . . just one more thing.

Got the measurements for buckets and rear bench. All I need is the lateral location of the rear bench buttons. I'm guessing they're 10 inches down from the top on the second seam out from the center pattern like on the buckets. Just would like confirmation.

Thanks again all.

Hey guys, thanks for all, . . . just one more thing.

Got the measurements for buckets and rear bench. All I need is the lateral location of the rear bench buttons. I'm guessing they're 10 inches down from the top on the second seam out from the center pattern like on the buckets. Just would like confirmation.

Thanks again all.

Yes, they match the bucket seat back location.

Dan