Looking for a better choice for front springs on my 67, I pulled this info from a old Moog spring catalog.

http://www.hal-pc.org/~rthlc/64-67_front_springs.html


http://www.hal-pc.org/~rthlc/68-72_front_springs.html

It would be nice if this could be put in the Team Chevelle tech reference.

One thing I should note is that a lot of the part #'s are not listed as fitting a Chevelle. I looked at the way the ends of the springs were cut then included every spring in the book that was close in I.D. and length. 2 of them in fact were spec'd as 65 Impala REAR springs, (661 & 6041).

Also, this was a 1996 catalog so some of the numbers included may no longer be good but might cross to another brand or maybe pop up on ebay.

I used the 638s in a small block 67 malibu. Perfect ride height, but not quite stiff enough. It will rub a little on slow turns with a passenger up front. This is with 225 70 15 tire. Need to be up about 1/2 inch to clear, but it looks good IMO.

Some have used thr 6310 with success.

Good luck