SS_Chuck
Oct 19th, 03, 5:29 PM
I've torqued my upper and lower ball joints to the specified numbers. Of course the slots don't line up to the holes. Do I loosen or tighten to get the proper line up?
|
Theo Oct 19th, 03, 8:49 PM For my '68 Chevelle it is 80 ft. lbs for the lower and 50 ft. lbs for the upper. Theo. rick Oct 19th, 03, 9:35 PM My 72 factory assembly manual calls for : UPPEr - 40-60 lbs and 90 MAX to align cotter pin (NOTE-Do not back off nut for cotter pin insertion) LOWER 70-90 lbs and 125 MAX to align cotter pi with same Note. | ||