I broke the passenger side spindle on my 67 and it bent the lower control arm graemlins/angry.gif .I need to know what years will interchange with it.Do any of the monte carlo control arms work on a 67?Thanks in advance graemlins/thumbsup.gif --67_SS

Hey Danny,

I don't know about the Monte swap. (Sorry) But I know where there are are some '66-'67 Chevelles. I not sure if the owner will part them out but I can find out. Let me know if I can help.LOL

graemlins/beers.gif

Elmo

danny, according to the interchange manual, the 67-69 camaro,(except z-28)68-74 nova, 71-72 gmc sprint,71-74 ventura, 73-74 omega, and 73-74apollo will fit if you have drum brakes. the part # is 3966159. if you have discs, its the same with camaro, chevelle 67-72 also skylark, cutlass, 68-74 nova, 70-72 monte,71-72 sprint,71-74 ventura and 73-74 apollo and omega. the part# is 3966151. hope this helps. gus

danny, that info i gave you was for the spindle. for the lower control arm any 67-72 chevelle will fit, also 69-72 le mans, and 69-72 olds cutlass the part# is 3990510 rh and 3990509 lh.sorry for the mix up. gus

70 -72 Monte Carlo same as chevelle all the front suspension will interchange. So all the the lower control arms for 64-72 a & g body will work.

thanks guys! I just put EVERYTHING new under the front of my car.I changed from drum to disc brakes --- I leave the front end alignment shop and I got 10 miles down the road and an outer wheel bearing froze up and twisted the spindle in half.Luckily all it messed up was the caliper bracket(which I just paid 89.00 for the set)the brake shoes and the lower control arm---Could have been a lot worse !!!! I have a buddy with a monte carlo that I can get an arm off of---thanks again Danny graemlins/beers.gif

got the monte lower arm on today--replaced the lower ball joint caliper bracket and caliper bolts------good as new----thanks again guys--67_SS graemlins/thumbsup.gif

MAN! I just had my snap on the driver side, and when i pulled the passenger side the washer was torn through and starting to eat away at the actual arm, check both sides! Chances are you may need to do em both, I replaced the coil springs (2"drop) and bushings, washers, ball joints, end links... ahhh... almost finished.... good luck !!!!!!