I just got a 9" for my 66 from a 71 torino. Should work out pretty good once I get the spring perches and control arm mounts welded on--so that's my question. Anyone in the Iowa region know someone with the jig for this that'll weld these pieces on for me?

I'm looking for someone that sells the upper control arm mounts( for the rear end) for my Dana 60 conversion. Anyone???

BOBCAT, check www.quickperformance.com (http://www.quickperformance.com) web site. & 285 is for narrowing and jigging the rear end housing to fit your car, that includes the housing. I have a rear from a 85 lincoln w/ factory disc, he qouted me $200 to do the same using my housing. They are located in Gilbert Iowa,north of Ames 515-232-0126. Alot of dirt trackers do the same swap for there stock cars, but they use the metric cars-80's malibu,montes ect. The brackets are the same, but there shock mount location is moved in more. Your housing I think is wider than your stock housing.Check w/ a chassis builder in the waterloo area they may do this, there are a few here in the des moines area. Quicks includes paint and they look nice

REVS HI, I had a fellow say that you can get a housing off of the 80's montes, malibu and other GM equals and torch the brackets to use on you dana 60. You might check w/ quick they may sell them?? Hope this helps both.. Randy

Thanks for the information. I went down and got a housing from quick performance today and it looks excellent. I definitely recommend dealing with these guys for any of your needs. Turns out that they had a housing on hand with the perches and narrowed for cheaper than just modifying mine. Again, thanks for the pointer.